104.166.247.19
This Post Has Been Edited by the Author
In Reply to: RE: DIY Power Distributor posted by pixelphoto on May 18, 2017 at 20:43:20
Just a suggestion.
You could have used solid core copper wire for the hot and neutral conductors daisy chain connections from one duplex receptacle to the next. Instead of breaking the wire at each receptacle terminal plate connection instead run each hot and neutral wire continuous unbroken from one duplex receptacle to the next.
Method.
The wire will be unbroken and will half loop/curl around under the terminal screw of each outlet. Carefully remove just enough of the insulation from the wire that will be curled under the terminal screw. You can start with the last duplex outlet in the string and work toward the feed end so you can form the hot and neutrals wires for a neat and consistent looking job.
Jim
Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2017, Audio Asylum, all rights reserved ]
[ Take5 ]