Home Tweakers' Asylum

Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

"Solder would just have their [sic] own indentations"

So you're confident in saying that the solder is subject to microscopic porosity, but that the grease is not?

I would be more inclined to believe the solder would provide the more air tight joint, if soldered correctly. But Coner's "dab on top of the clips" wouldn't constitute correct soldering methodology.

The issue with the solder would be having to unsolder and remove the fuse from the fuse clip in the event of a failure. Sounds like a major pain in the ass. I'd like to try the silver grease though.





There are fuses made with leads, primarily for use on circuit boards. No telling how they'd perform. My only experience with fuse tweaking was trying a few recommendations made here on Tweakers Asylum. I wrapped the glass body in Teflon plumber's tape, and cleaned the end contacts with DeOxit. No change from a naked, dirty fuse. I flipped it for gits 'n shiggles to test directionality, but detected no sonic change.

I try and keep an open mind about things, but I guess I'm too much of a skeptic to spend $100 on a disposable fuse "Just to see".


"Suddenly, I'm not half the man I used to be. 'Cause now I'm an amputee" J. Lennon


This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.