Home Tweakers' Asylum

Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

Burn in jig

Making a burn-in jig for inductors is easy enough. Just take a resistor and connect it to one end of the inductor, and then connect the free ends of this series network to your amp in parallel with your speaker. I.e. one amp lead goes to the free end of the inductor, and the other amp lead goes to the free end of the resistor. You now have the equivalent of a 6-db low-pass crossover filter. The resistor value is not critical at all. It could be something in the 8 ohm to 20 ohm range, but it should be at least 10 watts. Then you can just run the amplifier with music signal. I have done this many times with resistors, capacitors and wire all hooked up to my video system and running 24/7. It should do just fine with an inductor as well.


This post is made possible by the generous support of people like you and our sponsors:
  The Cable Cooker  


Follow Ups Full Thread
Follow Ups
  • Burn in jig - Salectric 07:58:49 04/25/17 (1)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.