|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Do you put flux on the solder joint or on the wick? Thanks. posted by alaskahiatt on January 25, 2017 at 10:05:00:
I've always put it on the joint. Space allowing, I usually start with a spring loaded solder sucker. Then I follow up with some wick if there is any residue. Either way, the flux helps the "old" solder flow better, and cleans the joint at the same time.
I didn't know about the wick with the flux in it. Good to know as sometimes I get a little "outta control" with my flux use. Then I'm dealing with flux cleaner. Then flux cleaner cleaner. Sigh...
Cheers!
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Do you put flux on the solder joint or on the wick? Thanks. - Jonesy 11:31:15 01/25/17 (3)
- Thank you. My experience with the pump was exactly like yours. - alaskahiatt 21:33:31 01/25/17 (2)
- RE: Thank you. My experience with the pump was exactly like yours. - JURB 04:04:27 01/26/17 (1)
- RE: Thank you. My experience with the pump was exactly like yours. - MannyE 07:31:12 02/02/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
