Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tweakers' Asylum ]

---

[ Alert Moderator ]

---

Series inductance is not advised for power amp supplies.

Posted by Al Sekela (A) on March 10, 2009 at 15:52:07

In Reply to: Electronics specialists lab-quality filters posted by boodles on March 9, 2009 at 20:28:27:

The data sheet looks amateurish and the spec of 65 dB isolation is not likely to be met over the full 10 KHz to 250 MHz noise frequency range. Compare to the Corcom Q series spec sheet at the linked site.

Such filters work by using series inductors and shunt capacitors. Even though the inductance is small, it will still inhibit current to some power amps and affect their dynamics.

The capacitor dielectric materials also have an effect on the sound. I don't know what kind ESP uses, but it is likely they are polyester or polypropylene. Neither of these sounds good compared to metallized paper, IMO. Thus, these filters may not be the best choice for use with source equipment either.

Surge suppression with MOV devices introduces additional grunge, and the devices wear out over time.

Keep in mind that the company may think a high-end sound system includes a 7-channel receiver with about 50 microprocessors and horrid little switching amps inside.

• Corcom Q series   (Open in New Window)

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---