|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Replacing AQ Diamondback Plugs with Cardas SRCA posted by Seadog on April 14, 2007 at 05:29:49:
2nd, 'more wires' are 3 signal cables--1 positive and 2 common/ground/neutral/return. You can use an Ohmeter to verify that end to end.3rd and 4th, the drain wire is the connection for the shield, to equipment/connector common on one end only. "...providing total shield coverage without compromising the negative conducting path..." means the shield is NOT a signal conductor. AQ connects the shield at the load (= driven-equipment) end. If you wanted to make your job a little easier, cut the cable to length while leaving the load-end connector on--that is, cut off the supply-end connector--and you won't have to deal with the shield.
One more suggestion--I and many others love Cardas Quadtectic solder. It sounds great, and because it melts at a lower temp than high-silver-content solders, it's easier to use. If you'll e-mail me at jeffreybehr(at)cox(dot)net with your mailing address, I'll send you some, free.
Good luck.
-------------------------------------------------------
Tin-eared audiofool and obsessed landscape fotografer.
http://community.webshots.com/user/jeffreybehr
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- 1st, I recommend you retain the AQ connectors--they sound good and are easy to install. - jeffreybehr 10:29:19 04/14/07 (3)
- Whut he said. - Poindexter 14:35:48 04/14/07 (2)
- Poin, no I haven't tried the Tri eutectic solder. Is that Cardas? - jeffreybehr 17:15:44 04/14/07 (1)
- Yah. - Poindexter 18:36:57 04/14/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
