Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: MDF posted by Al Sekela on January 23, 2007 at 12:56:18:
I will not use MDF.Only because this is a project I want to fully enjoy - and I enjoy wood.
When I listen to music, my main goal is to have fun doing it, but as I listen, I *see* my equipment and just for this once, I want it to look good (ain't I fancy?). I would not let this way of thinking dictate my equipment choice, but I figure it is not to bad in the case of a low cost week-end project!
I have been reading through the Asylum for most of the day now and here is where I am at in my reflection :
I want to go with a 1/4 inch Balsa plate covered (top and sides -- so the balsa would not be seen) by a inch or 1 1/2 inch thick wood (which?) slab. All that resting on Vibrapods or Isonodes (as a cheap yet working solution).
The first wo stages would then damp as the wood slab would isolate.
Doubled with a casing damping (sand bag? bluetack?) for the CDP, it should do it.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: MDF - remi 13:11:20 01/23/07 (2)
- MDF takes veneer as well as balsa or any other wood. - Al Sekela 09:55:07 01/24/07 (0)
- Try this - grailer 13:44:48 01/23/07 (0)