|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: replacing the IEC inlet with fuse holder posted by gilles on January 8, 2007 at 18:13:26:
If your replacing the IEC inlet for increased audio resolution, it would be silly to use a fuse holder.Solder the fuse to the wires and then heat shrink the fuse/wires :-)
Cheers,
~kenster
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: replacing the IEC inlet with fuse holder - kenster 18:24:12 01/08/07 (12)
- Soldering won't melt the fuse wire? - Dave Pogue 04:51:28 01/09/07 (10)
- Re: Soldering won't melt the fuse wire? - wheezer 15:00:01 01/10/07 (0)
- Nope. See it all the time in the electronics industry. nt - kenster 16:07:10 01/09/07 (0)
- Re: Soldering won't melt the fuse wire? - ramw 05:34:16 01/09/07 (7)
- Re: Soldering won't melt the fuse wire? - JB 09:44:32 01/09/07 (2)
- Then watch the end caps come off... - Thomas Martens 12:36:36 01/09/07 (1)
- LOL...yes if your using a 100 watt soldering iron...... - kenster 16:13:11 01/09/07 (0)
- Oh no! not the fuse thing again!... - Thomas Martens 09:10:26 01/09/07 (3)
- Re: Oh no! not the fuse thing again!... - kenster 16:06:14 01/09/07 (2)
- Well,... - Thomas Martens 14:34:16 01/13/07 (1)
- Re: Well,... - kenster 15:01:57 01/13/07 (0)
- Re: replacing the IEC inlet with fuse holder - gilles 21:31:32 01/08/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
