|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Tube crossover: DIY or Off the shelf? posted by 45drive45 on September 30, 2002 at 03:27:41:
If you combined Steve Bench's and TubeCAD's ideas, you can easliy change xover points. With a 12dB xover you'd only need to vary 2 resistors (per channel) if you use a bipolar power supply. If you used a couple of those 11 position 4 pole switches from ebay you could have 11 different xover points. Just build it like a series stepped attenuator. olen
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Tube crossover: DIY or Off the shelf? - olen 10:50:29 09/30/02 (1)
- Many thanks to all who posted; most helpful<nt> - gware 08:12:09 10/01/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
