|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: question for Kurt Strain (power supply modulations of p-p vs SET) posted by WCT on July 29, 2002 at 12:38:40:
As far as pulling on the PS there are a few things to look at. For a se design, there wil be draw as the waveform goes positive, then it will approach zero as the current requirement drops below idle level( at high volume). A pp operating in class A will have a continious draw on the ps, ideally all the way to full volume. As one tube draws more the other will draw just an equal amount less. A pp AB amp will have a very varied draw on the PS. each peak will cause a large draw form the PS. even worse than a SE, so I'd rank them as easiest to hardest as pp class A, SE, then pp AB. to make a long story short....
regards,
Douglas
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Pull on PS - Sector-7G 12:50:05 07/29/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
