|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Need Help, Confusing test result from tube tester posted by Andi on March 8, 2002 at 20:30:19:
I ran in to the same problem. I bought (Ebay) a B & K model 700 tester. I had been using a tester that a fella has here in Denver. Different results (drastic) between the two testers. I found an internet site that has helped me a lot. It is the Test Equipment Forum
on the Antiques Radios site.
www.antiqueradios.com
Select "Forums" in header
Select "Test equipment" in list
What I was told to do was replace all electrolytic caps, check all resistors for value drift (replace if too far off), and, most importantly, CALIBRATE the tester. I purchased a manual and am proceeding into the parts replacement and calibration.
Hope this helps!
JimA
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Need Help, Confusing test result from tube tester - JimA 10:47:12 03/09/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
