|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Plates cherry but only a small spot posted by overclocker on June 25, 2001 at 20:40:46:
Heres another area for concern not mentioned very much - the heater voltage. Make sure it is not too much over 6.3V. If it is up at 6.7 or 6.8, I would knock it down with low value power resistors. Many will tell you don't worry - this is uninformed thinking. High heater voltage can cause cherry red spots as well.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Plates cherry but only a small spot - BFitz 23:37:51 06/25/01 (1)
- You have made an important and fundamental point...... - Shorted Turn 20:10:36 06/26/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
