|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Dyna PAS3a Disappointment posted by Wayne on December 11, 2000 at 12:53:17:
The basic design is ok and is sensitive to the tubes used.I would replace all of the caps and resistors to start. Then upgrade the volume and balance pots. I would pay attention to the length of the wireing- channel to channel. I would also remove the filter, loudness and tone control circuits.
Yes a lot of work, but you will end up with a fine sounding pre-amp.
As I said the basic design is good, it is let down by execution and secondary parts.
Best,
Ross
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Dyna PAS3a Disappointment - Ross 11:23:34 12/12/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
