|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Output trans for EL84 instead of 6BM8 posted by george vasileiadis on October 12, 2000 at 15:56:43:
Found you something at duncanamps.com. Enter those tube numbers at http://duncanamps.com/tubedata/tubesearch.html and you'll find the opts can be used those tubes. Note the EL84s running at 250 V will deliver about twice the power of the 6BM8s at 200V, at the same impedence, 5200 ohms single ended (S/E). I suspect you'll see the same results with PP operation. The opts might run out of oomph though unless the amp was overdesigned in this area. It would sound sloppy beyond the design output of the transformers. Could'nt hurt to try though. Good luck, jacK.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Output trans for EL84 instead of 6BM8 - palomarjack 01:31:45 10/14/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
