Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Repairing damaged trace on circuit board posted by lafish54 on July 8, 2022 at 14:23:01:
Without photos it is difficult to advise, but in general it should be easy to repair. First I would cut off any tracks that are hanging off the board. Determine which components the track connected and replace the track with a piece of 22 gauge wire. For instance if the track goes between one leg of the capacitor to a resistor or tube pin, simply loop the wire around the capacitor lead and solder; then loop around the resistor and solder. Whether you leave the insulation on the piece of wire or not depends on the application.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Repairing damaged trace on circuit board - Palustris 07:46:15 07/12/22 (1)
- Agree - Triode_Kingdom 16:02:36 07/12/22 (0)