Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
I had a post here that covered several issues & now I have one final question. In the other post it was established that low value fuses have a DCR of around 3 - 5 ohms. I am repairing a tube amp that has 125mA fuses (4) in the cathode auto bias ckt for the power tubes (4 KT88s). I don't know auto bias ckt designs, but these have an LED in the ckt. I have some 125mA fuses that measure 3.4 ohms DCR (original) & some that measure 6.3 ohms (new). I don't have enough of either to replace all, so I am wondering if I should order more. (6.3ohms) Is it important to have the fuses be all the same value, or is this not an issue. I know it may be hard to answer without seeing the ckt, but I don't have the schematic & haven't drawn up the ckt yet.
Thanks,
Kev
Edits: 04/30/22 04/30/22 04/30/22
This post is made possible by the generous support of people like you and our sponsors:
Topic - Tube bias ckt. component matching. - bugeyed 08:49:03 04/30/22 (6)
- established? who and where did they say that? - Story 09:26:03 04/30/22 (5)
- who and where - 1973shovel 07:56:46 05/01/22 (0)
- RE: established? who and where did they say that? - bugeyed 09:45:53 04/30/22 (3)
- RE: established? who and where did they say that? - Story 10:53:04 04/30/22 (2)
- RE: established? who and where did they say that? - bugeyed 11:13:55 04/30/22 (0)
- and you should always have extras - Story 11:00:05 04/30/22 (0)