Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
I am repairing a tube amp & there are fuses in the bias ckts. for the power tubes. (KT88s) The fuses (125mA) that survived the failure measure 3.4 ohms & new fuses measure 6.6 ohms. BTW I measured the fuses with a 22 ohm resistor in series. I don't have instructions for adjusting bias on this unit & am concerned about replacing some fuses with these new ones. I didn't notice, when I ordered the fuses but, is the DC resistance in the spec? So, should I be concerned about this variance (3.2 ohms) in the new fuses?
Thanks,
Kev
This post is made possible by the generous support of people like you and our sponsors:
Topic - DCR of small value fuses? - bugeyed 11:54:42 04/27/22 (10)
- Older Slo-Blo fuses have a small resistor inside - Alpha Al 12:37:47 04/28/22 (1)
- RE: Older Slo-Blo fuses have a small resistor inside - bugeyed 08:35:05 04/29/22 (0)
- 125mA Fuse - Triode_Kingdom 10:19:47 04/28/22 (1)
- Thank you TK nt - Tre' 10:44:52 04/28/22 (0)
- You have a measurement problem - Chip647 13:58:53 04/27/22 (5)
- RE: You have a measurement problem - Uncle Mike 15:11:17 04/27/22 (1)
- RE: You have a measurement problem - Tre' 20:13:06 04/27/22 (0)
- RE: You have a measurement problem - Tre' 14:14:14 04/27/22 (0)
- RE: You have a measurement problem - bugeyed 14:03:22 04/27/22 (1)
- RE: You have a measurement problem - Tom Bavis 06:58:33 04/28/22 (0)