Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Cleaning pins posted by J.Mac on May 18, 2020 at 14:31:20:
LCR cleaner. I get a mason jar lid, turn it upside down, filled it with LCR up to a point that I am sure will not reach the tube envelop of the 12AX when it is standing upright, place the tube(s), after 5 minutes, take the tube out, use toothbrush to clean, then dry it off with a clean dry rag.
Might work for you!Abe
Edits: 05/19/20 05/19/20
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Cleaning pins - amandarae 10:11:33 05/19/20 (9)
- good advice, but... - samstone 08:59:51 05/24/20 (0)
- RE: Cleaning pins - Steelhead Mike 15:32:22 05/19/20 (7)
- This one? - uncle mag 02:32:28 05/20/20 (1)
- RE: This one? - amandarae 13:27:52 05/20/20 (0)
- Ooops! My mistake. - amandarae 15:35:52 05/19/20 (4)
- RE: Ooops! My mistake. - acres verde 08:11:22 05/20/20 (3)
- RE: Ooops! My mistake. - Oface 10:05:19 05/22/20 (2)
- RE: Ooops! My mistake. - acres verde 10:39:18 05/22/20 (1)
- RE: sacks of corks in the living room - LtMandella 13:47:39 05/24/20 (0)