RE: Switches will wear out on you.

Posted by DAK (A) on December 26, 2016 at 18:21:03

In Reply to: RE: How about this. posted by sony6060 on December 26, 2016 at 18:11:05:

Also throwing a switch will usually cause a "thump" and seeing that thump on your speakers can be frightening.
Are you making a single ended or pp amp? If se, a 6106 will be adequate and has a very long 40+ seconds before fully conducting.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - 5V4 Warm up Time - sony6060 06:37:13 12/26/16 (13)

What's the definition of "warm up" time and how should it be measured?... - Steve O 11:30:40 12/26/16 (0)

It is easy to check for yourself - DAK 11:23:26 12/26/16 (9)

RE: It is easy to check for yourself - sony6060 11:55:55 12/26/16 (8)

Perhaps you should use a 5ar4? - DAK 15:02:52 12/26/16 (0)

RE: It is easy to check for yourself - Michael Samra 14:44:59 12/26/16 (6)

RE: It is easy to check for yourself - sony6060 16:39:50 12/26/16 (5)

How about this. - Michael Samra 18:05:21 12/26/16 (4)

RE: How about this. - sony6060 18:11:05 12/26/16 (3)

RE: Switches will wear out on you. - DAK 18:21:03 12/26/16 (2)

RE: Switches will wear out on you. - Michael Samra 23:24:28 12/26/16 (0)

RE: Switches will wear out on you. - sony6060 18:55:53 12/26/16 (0)

Here is a thread on DIYaudio where it was covered. - Michael Samra 08:48:10 12/26/16 (0)

It is not a super slow like the 5AR4 - Chip647 08:39:00 12/26/16 (0)

Follow Ups

RE: Switches will wear out on you. - DAK 18:21:03 12/26/16 (2)

RE: Switches will wear out on you. - Michael Samra 23:24:28 12/26/16 (0)

RE: Switches will wear out on you. - sony6060 18:55:53 12/26/16 (0)

RE: Switches will wear out on you.

Post a Message!