Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Question about power transformer specification posted by Tubenstein on November 29, 2016 at 15:50:02:
Are your planning to LIFT it after you build it? Some serious iron, good for a half an amp, used at 80 mA. Filtering could be better with bigger caps, especially at the output. Which will improve damping greatly too - with existing values, it will bounce madly with load transients.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Question about power transformer specification - Tom Bavis 10:13:22 11/30/16 (4)
- RE: Question about power transformer specification - Tre' 18:02:12 11/30/16 (2)
- RE: Question about power transformer specification - Tom Bavis 11:12:46 12/02/16 (1)
- RE: Question about power transformer specification - Tre' 18:11:54 12/02/16 (0)
- RE: Question about power transformer specification - Tubenstein 11:59:51 11/30/16 (0)