|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Replacement for screw type speaker terminals? posted by DAK on April 11, 2016 at 09:32:56:
There is a very simple trick to that. Get some prepunched perfboard (circuit board) with .1 inch spacing, cut it down to the same size as the item that you are going to drill. Use a sharpie to mark the holes you want to drill, for spacing etc. Securely tape the perfboard to what you are going to drill using clear packing tape, then drill away. The holes in the perfboard will act like a guide for your drill. You may want to start with a smaller drill and work your way up depending on how large a hole you are drilling.
Cal
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Replacement for screw type speaker terminals? - thermionic addictions 11:44:59 04/11/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
