![]() |
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: AES - SE-1 ? Can a first time DIY-er build this,.....how about..... posted by Scott on May 24, 1999 at 12:39:19:
Since you built one these maybe you answer a few questions. How was the original parts quality? How would you rate the original opts compared to the magnequests. Are they close in performance? How would you describe the sound of these amps right out of the box? Was there a problem with this amps handling of the 300bs? Knowing what you know now, would you buy this amp again? Ok its more than a few.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: AES - SE-1 ? Can a first time DIY-er build this,.....how about..... - Bill 14:16:12 05/24/99 (24)
- Re: AES - SE-1 ? Can a first time DIY-er build this,.....how about..... - Scott 15:24:34 05/24/99 (23)
- Re: AES - SE-1 ? Can a first time DIY-er build this,.....how about..... - Bill 16:51:25 05/24/99 (20)
- Re: AES - SE-1 ? Can a first time DIY-er build this,.....how about..... - Scott 08:26:59 05/25/99 (19)
- 2 points - Jack G 08:36:05 05/25/99 (18)
- Re: 2 points - Scott 09:57:57 05/25/99 (17)
- Re: 2 points - Jack g 11:05:54 05/25/99 (16)
- Huh? - Tom S. 12:04:26 05/25/99 (15)
- $phile 19 #1 - Jack G 06:40:46 05/27/99 (8)
- Re: $phile 19 #1 - Doc B. 08:44:58 05/27/99 (0)
- Thanks for the info. - Tom S. 06:56:32 05/27/99 (6)
- Re: Thanks for the info. - Jack G 07:18:53 05/27/99 (5)
- I squirted him an e-mail. - Tom S. 07:22:17 05/27/99 (4)
- Re: I squirted him an e-mail. - MikeP 08:58:21 05/27/99 (3)
- Re: I squirted him an e-mail. - Tom S. 09:19:34 05/27/99 (2)
- context - MikeP 09:56:14 05/27/99 (1)
- Ditto. I'll shut up now.(nt) - Tom S. 13:22:51 05/27/99 (0)
- Re: Huh? - Doc B. 17:14:56 05/25/99 (5)
- I've got the calculations straight. However, my reading comprehension..... - Tom S. 06:19:22 05/26/99 (1)
- I'll have to go back and read that bit-its been a while.;-( - Jack G 10:01:17 05/26/99 (0)
- Re: Huh? - MikeP 04:59:12 05/26/99 (2)
- Did you have to modify cap/resistor values to... - Dave VH 15:59:37 05/24/99 (1)
- Re: Did you have to modify cap/resistor values to... - Scott 10:00:44 05/25/99 (0)