|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Do I put that resistor in the circuit to ground? Did you mean 7591's? posted by Tom Bavis on March 13, 2007 at 11:25:29:
Thanks.
I will put in the 240 ohm resistor.
My Triplett tube tester won't test these 4 nice Sylania 7591s - they're too 'modern'. I wish my Eico 667 tester wasn't acting up but I can't trust the readings. That's a good tester.Pete
Vintage Voltage Expo - Denver, March 25
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Thanks again. - PeterI 14:35:24 03/13/07 (1)
- Any suggestions about upgrading this amp welcome (nt) - PeterI 21:05:41 03/13/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]