Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: How to measure the load of output of an AMP? posted by yac70 on February 15, 2007 at 02:36:46:
You may not be able to figure that out by measurements, as each designer sets those points by his preference, using his vision and objective. At any rate such measurements are hard to do correctly. My recommendation is to simply look at the output transformer wiring, there might be enough clue in that to figure out the setting.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: How to measure the load of output of an AMP? - Victor Khomenko 06:20:07 02/15/07 (0)