|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Blown Fuse - Part 2 posted by marklar on February 2, 2007 at 19:40:36:
Blowing fuses when all the tubes are pulled is bad news and generally points to a shorted power transformer. At least that has been my experience in those normally rare cases.
If you have an ohm meter check to make sure there is no continuity between the primary and secondaries, and measure resistance on the legs of the secondaries. If you have center taps,the resistance should be the same or close to the same between the legs and the center tap.Stu
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Blown Fuse - Part 2 - unclestu52 21:00:39 02/02/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
