Tubes Asylum Questions about tubes and gear that glows. FAQ

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Tubes Asylum ]

---

[ Alert Moderator ]

---

Re: Ponderings on the PV10 vs. PV-12

Posted by erik_squires@hotmail.com (A) on July 21, 2006 at 05:06:44

In Reply to: Re: Ponderings on the PV10 vs. PV-12 posted by unclestu52 on July 21, 2006 at 02:14:26:

So, with the disapearance of ps, what does CJ use insteaed for bypass caps?

Ahhh, filament ground, let me take another measurement, I was measuring across the 5W 100 Ohm resistor that's attached to the volume pot.

Speaking of spare caps, the thing about Julia Child's cooking that always got to me is that she always had all these "spare" parts lying around to throw in her cooking, so there was no way to just go out and buy what you needed and start cooking. You had to make a bunch of other meals to have the spare parts. :)

I'm a little leary of doing more to this preamp than adding the filament cap, and perhaps the 2 diodes (1/side). Suggestions on type?

The diagram on the top right of the PDF was a little hard to understand, could you tell me what I should be seeing?

Thank you again,

Erik

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---