|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Understand about drilling holes.... posted by doodlebug on August 23, 2005 at 12:34:51:
Hi doodlebug,I agreed with you, the same technique should be applied to the M-9. Now, i can calibrate the bias current to 55mA across the resistor.
But, the meter without the pin looks very strange so i still want to get a replacement meter if possible.Regards,
Alltec
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Understand about drilling holes.... - alltec marantz 9 12:45:11 08/27/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
