Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Question on impedance tabs vs. loudspeaker impedance posted by jwitzsch on September 16, 2004 at 02:26:06:
It's a complicated issue. The impedance curve of any speaker is not constant with a large abberation at resonance, not to mention a passive crossover with insertion loss or gain and the damn wire problems. You just have to try different taps with your speakers and your cables and see what best suits you. I would reduce the cable run as much as possible. I use 1 foot and my amp is at the speaker. Start low. Ray Hughes
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- It'a a toss up between good damping and extended highs - grhughes 06:54:53 09/16/04 (0)