|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Will the Wave 8's work? with system photos posted by ShaneB on May 4, 2004 at 20:48:12:
With the tweeter and a proper crossover, overall speaker system sensitivity will likely be lower. BTW, if the Dayton crossover is one of those off-the-shelf, fits-all generic ones from PE or such, then you owe it to yourself to design a crossover specifically for your drivers and enclosure- that's where your biggest improvement will be realized. The Wave 8's have only 8-ohm output tranformer taps, but the rule of thumb for tube amps is that speaker impedance should be equal or lower than that specified at output tap(s). I'm using a similar 8-watt/channel tube amp with 85-87dB speakers in a room twice as large as yours with fine results.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Will the Wave 8's work? with system photos - Ron Oehlert 00:40:35 05/05/04 (7)
- Re: Will the Wave 8's work? with system photos - ShaneB 08:22:17 05/05/04 (6)
- Re: Will the Wave 8's work? with system photos - Ron Oehlert 10:09:30 05/05/04 (5)
- Re: Will the Wave 8's work? with system photos - ShaneB 15:02:50 05/05/04 (4)
- Re: Somethings not right - Ron Oehlert 03:57:54 05/06/04 (3)
- Re: Somethings not right - ShaneB 12:21:15 05/06/04 (2)
- Re: Somethings not right - Shane Bevel 12:22:14 05/06/04 (1)
- Re: Post 'em if ya got 'em - Ron Oehlert 13:14:21 05/07/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
