Questions on 6V6SE schemaitc

Tubes Asylum

Questions about tubes and gear that glows. FAQ

Can the experts of this forum please give me some advice concerning my schematic. Most of the questions concern the feedback and the 12AX7 setup.
Will the values i have set for the resistors on the cathode of the 12AX7 work, same for the plate.
Also are the values chosen good values, for instance the 4.7uF cap, will it hurt to go higher to posibly 22uF or 47uF.
Also will the setup with the switchable feedback work well if i turn it off, considering both triode and pentode mode?
Any feedback conserning the size of the triode resistor aswell is 135ohms good or should i use about 180ohms?
if i implement the feedback cap, what will be a good value, or should i learn how to use a scope and signal generator to determine this?
are 25V caps acceptable for the 6V6 bias caps, or should i goto 50V, also will it hurt to use a 220uF instead?
i was told to use star grounding, what is this and what are the benifits, is there a tutorial?
any other feedback or suggestions is appreciated
thank you very much,
RaÃºl - rvas18

[See schematic at link below]

http://www27.brinkster.com/gulgcoast/schematic.html (Open in New Window)

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

Topic - Questions on 6V6SE schemaitc - rvas18 07:54:54 01/08/04 (0)

You can not post to an archived thread.