|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: Reflow Solder on 6SN7 Sylvania Chrome Domes posted by bryan on September 23, 1999 at 10:39:32:
***No soldering involved. Just heatNo, don't do it that way. Just heating the joint without any flux will only oxidize and burn the solder and create a wreck of a joint. If you decide to go ahead and reflow it, make sure you use at least some flux. If you don't like the idea of using some "modern" fluxed solder, then use a bit of rosin, or rosin desolved in alcohol, it works absolutely great. You need a clean shiny joint.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Definitely use flux - Victor Khomenko 10:56:15 09/23/99 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
