It will work either way.

Tubes Asylum

Questions about tubes and gear that glows. FAQ

205.175.225.5

In Reply to: How do you remove the negative feedback? posted by Eric U. on May 17, 1999 at 20:25:21:

Although the specs will be "worse" if you do a triode mod and/or remove the NFB. Rely on what you hear for a preference decision.
The purple wires that are attached to 8 ohm terminals are the NFB wires (they are crimped together with the output trannie wires at the 8ohm terminal). They run from the 8 ohm taps, underneath the power supply board, and are connected near the middle/top of the main board. The are labeled "Left NFB/ Right NFB" in etching on the main board. Just desolder these two wires from the board and tape them off with electrical tape to prevent shorting something out.
The triode mod and/or NFB removal voids the warranty on the amplifier.
Tom S.

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

Follow Ups Full Thread

Topic - How do you do a triode mod to the Jolida 202A(nt) - Eric U. 09:11:56 05/17/99 (4)

Same as the 302A/B. - Tom S. 09:20:23 05/17/99 (3)

How do you remove the negative feedback? - Eric U. 20:25:21 05/17/99 (2)

Ooops. You have the 202. - Tom S. 05:46:56 05/18/99 (0)

It will work either way. - Tom S. 05:42:42 05/18/99 (0)

Follow Ups

It will work either way. - Tom S. 05:42:42 05/18/99 (0)

You can not post to an archived thread.