Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: tube output stage help posted by raju on September 7, 2003 at 08:06:01:
Raju,Just a suggestion... Probably best to measure the A+, B+, C+, etc points after you've put in the 10H choke. Then, you can compensate for plate voltage and idle bias on each of the gain stage tubes---by varying the resistances, if necessary.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: tube output stage help - steve oda 09:07:12 09/07/03 (0)