To run these specs on the old RS 40-1354 and come up with cab dimensions and vent size. I'm using two drivers magnet to magnet, side firing and using them for LF duty. Any suggestions on stuffing would be great. I was gifted with a small stash of these and want to do something with them. No knowledge of design software. Thanks for any help you can give.
Specs that I can find:
RE = 7.09 ohm
f0 = 56.0 Hz
SD = 0.0083 m^2
Mmc = 6.16 g
QM = 3.46
QE = 0.537
QT = 0.46
Vas = 0.013 m^3 = 0.457 ft^3
eta (2 pi) = 0.414%
Sensitivity 88.7dB/2.83v/m
This post is made possible by the generous support of people like you and our sponsors:
Topic - Would Someone Be Willing - tubav 17:59:10 11/29/20 (7)
- RE: Would Someone Be Willing - airtime 08:29:07 11/30/20 (6)
- RE: Would Someone Be Willing - tubav 11:14:01 11/30/20 (5)
- RE: Would Someone Be Willing - Duke 20:13:07 12/01/20 (0)
- RE: Would Someone Be Willing - rivervalley817 12:19:52 11/30/20 (0)
- Did you come across this push-pull design? - Jonesy 11:56:19 11/30/20 (2)
- RE: Did you come across this push-pull design? - tubav 12:25:10 11/30/20 (1)
- RE: Did you come across this push-pull design? - Jonesy 13:02:37 11/30/20 (0)