In Reply to: Then of course what happens next... posted by ghost of olddude55 on November 23, 2020 at 14:04:46:
try zapping it with a 9V battery while carefully observing the cone movement. if it's rubbing it should deform towards or go off kilter to one side or the other, remount it with that side up ... but always mark the top of a driver before you pull it
where I'm going with this is that often you can realign the VC in the gap by a 180 rotation of the driver while running a low level signal ... test signals work great for this ...
if you're already hip to this trip, carry on
regards,
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Then of course what happens next... - rivervalley817 14:18:38 11/23/20 (4)
- Might try it later. - ghost of olddude55 14:30:07 11/23/20 (3)
- RE: Might try it later. - rivervalley817 14:47:17 11/23/20 (2)
- They go deep, they just aren't punchy. - ghost of olddude55 14:53:54 11/23/20 (1)
- RE: They go deep, they just aren't punchy. - rivervalley817 15:05:37 11/23/20 (0)