After hooking up the 19's to my Mac I can't believe how great they sound! I just received all of the Sonicap Gen I caps and the mills resistors the other day to replace the stock ones. Getting ready to change these out in one speaker and do a comparison test with the other speaker. I noticed on some forums it would be advised to change the wire from the crossover to the drivers with thicker gauge wire. Any thoughts on that? Anything else I should do while I have the crossovers out? I would appreciate any ideas. I'm not a tech by any means but I can follow a few simple directions and solder.
This post is made possible by the generous support of people like you and our sponsors:
Topic - ALTEC MODEL 19 CROSSOVER QUESTION - ssimon@wideopenwest.com 10:59:44 07/13/17 (12)
- RE: ALTEC MODEL 19 CROSSOVER RESTORATION - ssimon@wideopenwest.com 19:21:30 08/06/17 (0)
- RE: ALTEC MODEL 19 ... Valancia Crossover capacitors - drummerwill 13:42:40 07/14/17 (0)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - Presto 21:51:29 07/13/17 (3)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - ssimon@wideopenwest.com 12:50:06 07/19/17 (0)
- Comparing - Inmate51 07:26:37 07/14/17 (1)
- RE: Comparing - ssimon@wideopenwest.com 12:51:22 07/19/17 (0)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - Idler 19:45:55 07/13/17 (0)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - dee eye why 18:22:23 07/13/17 (0)
- Be sure to deal with the four ground lugs on the crossover board.... - viridian 14:50:34 07/13/17 (1)
- RE: Be sure to deal with the four ground lugs on the crossover board.... - ssimon@wideopenwest.com 12:53:14 07/19/17 (0)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - KanedaK 12:47:44 07/13/17 (1)
- RE: ALTEC MODEL 19 CROSSOVER QUESTION - jaynemo 13:56:08 07/13/17 (0)