Home Speaker Asylum

General speaker questions for audio and home theater.

RE: External Crossover For ATC SCM19's

Good point. Didn't even consider the microphonic aspect. My primary motivation was to clean up the sound as best as possible, given the fact that the SCM19 has top shelf drivers, but the crossover parts didn't match the driver quality. Just using non inductive Mills resistors alone helps out a lot compared to the stock resistors. The Mundorf caps and foil coils also help.

Many of my favorite recordings sound as if a "master recording version" was suddenly discovered. Much bigger difference for the better than I thought it would be.


BTW, the Paul Klipsch reference harkens back to the golden age of audio. There still is something special about listening to a tricked out set of K-Horns (or high end horn setup) through a single ended triode amp. Not practical for many living conditions. Therefore, monitor/sub solutions work well.
" Don't look back. Something may be gaining on you"

Satchel Paige


This post is made possible by the generous support of people like you and our sponsors:
  McShane Design  


Follow Ups Full Thread
Follow Ups
  • RE: External Crossover For ATC SCM19's - Freo-1 06:17:04 11/28/15 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.