In Reply to: Vandersteen Model 1 crossover removal posted by marknoir on January 26, 2008 at 22:02:58:
If its not to hard take the good speaker apart and get the color codes from that resistor. One other suggestion, if you can't get the board out clip the resistor and leave as much wire there as you can. Then re solder the new part(s) on to the wire left on the board.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Vandersteen Model 1 crossover removal - Dale 10:59:50 01/30/08 (0)