In Reply to: Speaker load vs. Sensitivity with a tube amp posted by gnugear on March 31, 2007 at 09:30:36:
8 Ohm speaker must be connected to 8 Ohm tap, and 4 Ohm speaker to the 4 Ohm tap. Any attempt to use mismatched load will cause not only loss of power, but significant change in frequency response.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- With a tube amp, - sser2 18:23:20 03/31/07 (4)
- Blah Blah - Stale 20:42:25 03/31/07 (3)
- Re: Blah Blah - sser2 22:34:43 03/31/07 (2)
- Re: Blah Blah - Stale 07:49:32 04/01/07 (1)
- I was just going to add that detail - E-Stat 20:47:54 04/02/07 (0)