Home Speaker Asylum

General speaker questions for audio and home theater.

Re: Limited vertical dispersion speakers

Hi Bill,

The rules permit me to answer specific questions, and that sounds pretty specific to me. If the moderators feel otherwise I'm sure they'll let me know. Here are the lines I carry, with comments on their vertical dispersion characteristics.

Listing them roughly from most-to-least expensive:

1. SoundLab electrostats, which are tall line-source-approximating dipoles. Their geometry pretty much precludes floor and ceiling reflections. These are by far my most directional speakers in the vertical plane.

2. Gradient, which uses a coaxial mid/tweet unit wherein the midrange driver's cone acts as a waveguide to control the radiation pattern in the lower end of the tweeter's range.

3. GedLee Summa, a large high-efficiency speaker that uses a 90 degree constant-directivity round waveguide to control the radiation pattern above the 1 kHz crossover point.

4. AudioKinesis (my house brand), similar in configuration to the Summa but on a smaller scale. I'm also working on a coaxial model or two, which would resemble the Gradients in dispersion characteristics.

5. Gallo Acoustics. The MTM format of the Reference series has limited vertical dispersion. I don't know the frequency at which the piezo tweeter takes over but it's probably pretty high; that would make a difference because the piezo will have considerably greater vertical dispersion than the two cones will.

Hope this helps!

Duke


This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  


Follow Ups Full Thread
Follow Ups


You can not post to an archived thread.