In Reply to: JBL 4312A crossover needed posted by Redsoxer on February 23, 2007 at 16:49:59:
These worked with my crossover rebuild of my early vertical array JBL L100's. Two pads side by side just fit with no room to spare. A couple of concerns are make sure you have adequate space for them on the X-over board (I think they are 2 1/8" square but double check that)& the shaft diameter is too small to allow using the original JBL black adjustment knobs (at least for the L100 series). I was contemplating securing them with GE silicone, but opted to just leave them off, as everything is hidden anyway with the grills on. PM me, I believe I have a photo of my rebuilt X-overs showing the application.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Madisound LP50 - jaynemo 02:50:04 02/26/07 (0)