|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
I Recently aquired a pair of Ohm Walsh 2's and one of the speakers has a broken spring clip. It is obvious that this speaker was not built with future repairs in mind, and Ohm says that they have not heard of a successful replacement for these as they are soldered directly to the wires of the input board. I would like to replace this somewhat cheap setup to 5-way posts, but would settle for a solution that would get me up and running without fear of the wire falling off under load.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Broken Ohm Walsh2 spring clips - justanotherguywithaquestion 16:39:16 05/25/03 (8)
- Re: Broken Ohm Walsh2 spring clips - ERG 18:03:16 05/26/03 (0)
- Sorry I don't know the answer . . . - Hoho 18:38:35 05/25/03 (6)
- Re: Sorry I don't know the answer . . . - justanotherguywithaquestion 07:08:03 05/26/03 (4)
- Re: Oh . . . - Deckers1 07:51:09 05/26/03 (3)
- Re: Oh . . . - justanotherguywithaquestion 15:46:43 05/26/03 (2)
- Re: Oh . . because it looks rediculous to someone who likes . . . . - Deckers1 23:47:30 05/26/03 (1)
- Which are you saying . . . - Hoho 08:20:28 05/27/03 (0)
- Re: Solder it ! . . . - Deckers1 22:33:30 05/25/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
