|
General Asylum General audio topics that don't fit into specific categories. |
|
|
|
General Asylum General audio topics that don't fit into specific categories. |
|
In Reply to: Just bought a house prewired with speakers- attempting to set it up properly. posted by chasetcurry on July 2, 2012 at 10:22:23:
use the Niles SS-6 as below, push all the buttons in. Put this on the Zone 2 output of your theater receiver. Make sure your internal amp can handle a 4 ohm load! Select Zone 2 for another room.
If you have more than six locations you are likely better off with an external multichannel amp.
Just plug two wires in at a time until you figure out what is what, and label them! Hopefully there is at least some way to figure out + and -, but it will work out.
The Apple can go in as a separate input. Most receivers will let you rename inputs. I use an Onkyo and it is fine.
Steve
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I have done this...if you have no more than six locations... - Steve Parry 13:17:31 07/02/12 (5)
- RE: I have done this...if you have no more than six locations... - chasetcurry 19:43:33 07/02/12 (3)
- It is possible ... - reelsmith. 06:29:07 07/03/12 (2)
- RE: It is possible ... - chasetcurry 07:00:43 07/03/12 (1)
- RE: It is possible ... - chasetcurry 06:23:04 07/04/12 (0)
- Thanks for the link, Steve ... - andyr 19:15:01 07/02/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
