Home General Asylum

General audio topics that don't fit into specific categories.

R we sane and logical here?

Audio equipment is designed to run on 50 or 60 Hz AC power. Unfortunately, the good intentions of the equipment designer do not in themselves make the equipment totally insensitive to electrical noise of other frequencies on the power wiring.

If nothing but 50 or 60 Hz AC was present in your power distribution wiring, then this would not matter. If roads were perfectly smooth, cars would not need springs or dampers ("shock absorbers" in the USA). The two situations are about as equally likely.

Power cords act as filters for the electrical noise, whether the cord designer was aware or not. Some of the fancy ones are designed to avoid making the noise problem worse. There is much more involved in this than simply shielding or not shielding.


This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups
  • R we sane and logical here? - Al Sekela 14:22:05 02/13/07 (0)


You can not post to an archived thread.