|
General Asylum General audio topics that don't fit into specific categories. |
|
|
|
General Asylum General audio topics that don't fit into specific categories. |
|
In Reply to: Re: Once again...................... posted by Dan Banquer on August 17, 2006 at 09:13:45:
>>"Yes; but the real issue here is how much voltage is there on an earth grounded chassis."<<
>>>>>>>>>>>>
Zero...It is being bleed off through the equipment grounding conductor back to the neutral/ground bar of the electrical service panel then on out the service entrance neutral conductor to the source. Though the current flow is very small never the less it is there. Some of the very small current may travel thru the ics to the next ic connected component and travel back out its equipment grounding conductor back to the source. Does it effect the the power supply and the sound quality of the component if the ac polarity orientation is not correct? Yes. You need to reread Hansen's post. I just bet you every Hi-End manufacture does the same thing as Hansen and Curl does. Bob Crump also did it when he was alive.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Once again...................... - jea48 21:27:48 08/18/06 (1)
- Re: Once again...................... - Dan Banquer 04:59:55 08/19/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
