Home Digital Drive

Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it.

great workmanship

I must say that this is very sound advice....since I have effectively done 1-4.

--- That looks like some pretty sweet workmanship. You obviously used the same stand design that I did. It makes them look far more expensive than they are. When you go fully active, someone here might be willing to buy those inductors. Gone with the power eating resistor as well.

Take a look at my system and you will see some picts of 1. and a steroids version of 3 with the drivers wired directly to some WBTs.

--- Directly coupled to an sctive set up, these speakers will really rock. Do have a look at that Forte. While I haven't heard it on them, it sounds fine. + is fairly reasonable in cost.

But that is just it, My PC already out performs my old 2k trans/dac front end, and the PC is all ready for active crossover duty. IMHO cds are dying.

--- One question, did you have the old setup with the current config of your speakers. Asking since the mods do make a big difference that may invalidate the comparison. I find CDs OK. My system is only disc based so if I can only find the music that I want on CD, I guess I am stuck with that.

I currently have an anthem amp 1 to go with the pass, but that amp just never did it for me....so the next step is better amps, and then better Mags.

--- If you ever sell the Pass, do look me up.



This post is made possible by the generous support of people like you and our sponsors:
  Michael Percy Audio  


Follow Ups Full Thread
Follow Ups
  • great workmanship - Ozzie 11:15:06 02/01/07 (1)


You can not post to an archived thread.