Home Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Low mass / 47Labs Stratos IC plugs not working with new setup

I've been using 47Labs Stratos cables and plugs as interconnects for ages, without issues, but now I've run into problems.

I'm experimenting with a new low-budget setup, consisting of an old MacBook Pro and a cheap old DVD players as sources; which are connected to a Topping E30II DAC (also testing a Smsl C100), and then connected to a Fosi V3 amp.

When I use the 47Labs Stratos cables and plugs as interconnects between the DVD player and DACs, and between the DAC and the amp, they sometimes work for a little while, sometimes they don't work at all.

I have several of the Stratos interconnects, re-wired and cleaned them etc., yet the issue persists with all of them.


Now if I use a cheap RCA connector, and for testing assemble them in a very shady way, it always works. (images #1)

Even if I only use the center pin, and the Stratos ground plug, it does work too. (images #2).


Any ideas what the root cause of it may be?
A weak signal from the new DACs perhaps, too little contact surface, the mass of the center pin?

I'll try to attach the images in following postings, not sure how else I can do it here; sorry about the mess.

Warning: terrible craftsmanship, used for testing purposes only.




Edits: 10/02/23

This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Topic - Low mass / 47Labs Stratos IC plugs not working with new setup - horst 09:29:04 10/02/23 (14)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.