In Reply to: RE: Big +1 on the Furutech IEC inlets posted by Salectric on April 12, 2017 at 05:14:06:
I got the FL-06 NCF Rhodium with the set screws. Because of the set screws there is only one way to orientate it i.e., screws on top with ground on the 'higher' side. My original IEC inlet was orientated the other way (with ground on lower side). In my component one of the the wires had very little slack in it and it just managed to terminate it in the set screw housing.
But all was successful in the end.
Very happy.
Bob
"You have to leave something to your imagination"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Big +1 on the Furutech IEC inlets - Heifetz 12:12:47 04/12/17 (1)
- RE: Big +1 on the Furutech IEC inlets - bcowen 05:49:38 04/14/17 (0)