Hello All, I purchased Viablue NF-S6 cable to make my own XLR cables. This is there top of the line cable. It is very thick and has the following components.
1.Top outer layer 16mm inside tube Inside metal foil sheilding and air tubes all around.
2.Second Layer tube 10mm inside gold foil shields and 3 conflicting strand coil shields.
3. Inside there is a center air tube and 6 white cables and 6 black cables of the same size. Surrounding these are two counter wound wire shielding.
The way I have thought I should wire is. Pin 3 Black 6 strands, Pin 2 White 6 Strands Pin 3 Surrounding mesh.
Does this sound right or should the most external shielding meet with the internal shield to meet at pin 1?
Thanks for the suggestions.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Custom XLR Viablue NF-S6 cable - RIQUE 14:53:09 02/05/17 (7)
- RE: Custom XLR Viablue NF-S6 cable - mitch2 20:43:15 02/05/17 (6)
- RE: Custom XLR Viablue NF-S6 cable - wires 07:13:10 02/07/17 (5)
- RE: Custom XLR Viablue NF-S6 cable - mitch2 09:51:52 02/07/17 (4)