In Reply to: Well, it may LOOK complicated, but from an amp's perspective, it's not. posted by jeffreybehr on April 2, 2007 at 09:50:31:
I understand what you're saying. There is no crossover after the amp and so there is no filter to overcome. You have a direct connection to each voice coil.
But, you have eight reactive loads hooked up simultaneously to one amplifier output. Perhaps each load has a slightly different length of wire getting back to the amp too. I'm not so sure you can classify that as a simple load. Simpler than going through a crossover, maybe. But not simple like single driver simple.
It's all academic though because it is working so well for you. I'm just thinking out loud. That's a big 2.5 Watts in the EM7! Impressive.
Btw, all of your projects look like a lot of fun. What were we talking about ? . . . . oh yeah, wire. I get sidetracked so easily.
This post is made possible by the generous support of people like you and our sponsors:
- less complicated without a crossover and bandwidth limited too - Quiet Earth 11:29:45 04/02/07 (0)